1/13/2024 0 Comments 22008 yamaha ecu flashHere is the Rocker-Arm rotated away, which disconnects the ECU from the cable bundle: This rocker arm needs to be gently rotated away from the ECU body (to the left in this photo) The connector has a rocker arm latching mechanism as seen in this photo: The ECU is also connected to the wiring harness cable bundle via a plastic connector The ECU is secured in place with a rubber boot (that attaches to the rear sub-frame via two tabs) Goal: Remove ECU from the bike, taking care not to damage ecu or its connector Remove negative terminal cable from battery Goal: Render bike electrically safe, prevent damage to ecu and other electrical components. The ECU is on the left side, and has a cable bundle going to it Remove tail plastic (there are 3 sections of plastic fairing that need to come off) Goal: Remove tail section plastic to uncover ECU that is located in the tail, left hand side (clutch lever side) of bike. Some of the steps will be generic and not described in detail (ie removing tail section plastics) this post focuses more on the actual ECU details. Read the entire post to have a good idea of whats to come. This tech tip is meant to help give you an idea what may need to be done and is for entertainment purposes only. Here is a list of steps that should help to get you through the task of removing and re-installing the ecu, plus a few things you may need to do aftewards. You just decided to have your Tenere 700 ECU Flashed at a tune shop of your choice,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |